This Corvette reproduction antenna nut has been manufactured to original factory specifications using today's modern manufacturing techniques. You will find the fit, finish and function will work superbly for your…
Black plastic push-in guide, 1978 through 1979 1st design mounting hole in the rear body deck is sloped downwards towards rear. For use with factory style power antenna only.
…
This die cast, chrome plated spacer is angled.
The short side is 1/4 inch tall.
The tall side is 7/16.
O.D. = 1 5/16
I.D. = 3/4
There is a flange at the bottom which fits/snaps into gasket 162039
There is also a locator pin…
Correct reproduction zinc diecast chrome plated antenna nut used on all 65-68 Corvettes.
This antenna nut cap has the correct flats on the side of the nut and stepped lower edge where the nut mounts on top of the antenna bezel.
Hole…
Reproduction Of Original
The mast section of the antenna consists of four round chrome sections, three telescoping sections, and one fixed section, with an approximately 1/4" ball-shaped tip at the end of the mast. The overall…
Tapered mast as original (.100 at ball; .185 at mast).
Has correct .305 size ball.
This stainless steel antenna mast measures 31 1/2 inches overall length, with a thread size of 1/4 inch x 20.
…
Show Quality Reproduction
Replaces Non-Functioning, Damaged, Or Missing Originals
Includes Correct Serrated Cast Nut
Manufactured From RG59U Coax Cable
Threaded Collar On One End To Connect To The Antenna Itself
The Other End…
1979 2nd design through 1982 antenna hole in deck has a recessed forward mounting surface (level mounting for antenna nut). - Stainless Steel construction.
…